stainless steel filter technical data

stainless steel filter technical data

Technical data

Filter precision: 1-1000μm
Flushing time: backwashing single cycle process for about 23 seconds
1. Import and export routes:
In principle, the inlet and outlet diameter of the filter should not be less than the inlet diameter of the matching pump, which is generally consistent with the diameter of the inlet pipe.
2. Nominal pressure:
The pressure rating of the filter is determined by the highest pressure that may occur in the filter line.
3. the choice of the number of holes:
The main consideration is the particle size of the impurities to be intercepted, depending on the process requirements of the media process. The size of the screen that can be intercepted by various specifications of the screen can be found in the table below.
4. filter material:
The material of the filter is generally selected to be the same as the material of the connected process pipe. For different service conditions, filters of cast iron, carbon steel, low alloy steel or stainless steel may be considered.
5. filter resistance loss calculation
Water filter, the pressure loss is 0.52~1.2kpa at the general rated flow rate

Installation

This type of valve should generally be installed horizontally in the pipeline.
When installing and using, pay attention to the protection of the control box, sensor and transmission parts to prevent damage.
Connect the pipe according to the direction of the arrow on the stainless steel self-cleaning filter body
When adjusting the electric part, please note that the direction of rotation of the motor should be consistent with the direction of the mark.
Installation should be considered for easy access and a bypass pipe should be installed.
When installing, try to consider the sewage outlet at the bottom to facilitate the discharge of debris.
The sewage pipe is connected to the draining ditch, and the sewage pipe should not be too long.